Terrible vibration around 2700 RPM?
#1
Lucky owner
Thread Starter
Join Date: Mar 2001
Location: Tallinn ,Estonia
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Terrible vibration around 2700 RPM?
I recently replaced tranny & clutch. After all the work was done I noticed some vibration in low RPM area but when reving up to 3K then the vibration is terrible. At first I thought that the tranny is bad but vibration stays also when clutch is pressed.
Can anybody hel me?
thnx.
LLman
Can anybody hel me?
thnx.
LLman
#3
Lucky owner
Thread Starter
Join Date: Mar 2001
Location: Tallinn ,Estonia
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
I checed them. 2 of them on sides were ok but the middle one was bad & I made some modification to it. I pud a rubber hose around the metal part of the bushing and pressed it in. Mabye it's to tight now?
LLman
LLman
#5
Lucky owner
Thread Starter
Join Date: Mar 2001
Location: Tallinn ,Estonia
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Flywheel stayed on while i did the clutch & driveshaft is aligned. And yes it vibrates all the time Driving, standing,clutch on & off.
I'm confused.
I'm confused.
#6
Junior Member
Join Date: Oct 2001
Location: Cincinnati
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
I installed a new clutch a couple years ago and had the same problem. I found out the new clutch was out of balance, WHAT LUCK! My parts dealer replaced the clutch , but I had to reinstall it. Hope this helps
#7
Round&Round not Up&Down
Join Date: Aug 2001
Location: West Bloomfield, MI
Posts: 2,805
Likes: 0
Received 0 Likes
on
0 Posts
If it vibrates when standing still then it has nothing to do with the driveshaft. It has to be in the clutch plate itself. If it didn't vibrate b4 and now it does, then it has to be something you changed. I don't believe it's the tranny, I'd check the disc and PP.
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM