Yay. I'm installing my greddy fmic, and im at the part when i take off the stock TB elbow, and put on the greddy elbow. Thats all well and good, until i take out the air intake temp sensor(?) from the stock elbow. I tighten a LITTLE too much putting it into the greddy elbow, and snap it.

so i remove the mess, my elbow threads are fine.

Now i'm at home, going through my parts room, and i notice that my n/a UIM's have what looks like the same sensor on them. Is it the same? Can i use it?

thanks gurus

 

yes

 

thank you life saver