t2 wont rev past 5,200 rpm under load!!
#26
Full Member
Join Date: Dec 2002
Location: long island, ny
Posts: 51
Likes: 0
Received 0 Likes
on
0 Posts
i had a very similar problem. Once it hit 5200 it felt like it was hitting fuel cut when it was under boost. If i just slowly went up with no boost it wouldnt happen. I thought it was my FCD...i removed it and it stopped for a while...I was like ok fine..ill get a new one...But it started again before i put a new one in...It turned out the that the wire which plugs into the bottom of the pressure sensor had tension on it. I found this out because when i plugged the fcd back it i pulled some slack up on the wire, and my problem stopped..i dont know the reasoning for this but it worked. If i were you i would check out that wire and make sure it is not torn or under tension..
Thread
Thread Starter
Forum
Replies
Last Post