Stock air box cutting
Stock air box cutting
Ok look at the attached picture, i want to cut out the dotted line area. Is this going to give me better air flow or would it have some negative side effects?
just buy an adapter and filter off of ebay it cost me 35 dollars including shipping for the adapter and filter as a set and it works great. but if you want to do this it would possibly get better flow but not much more since this is the part of the filter that is basicaly smushed under the hood and it would bring in more hot air from the engine than a stock box would since the stock box is "sealed" from the hot air.
james
james
Trending Topics
ya that would be better with the head light out but take go speed go's advice and take off the cover and duct tape it or there was another post about glueing it down a while back you could try that too, but if you glue you can't go back so you'd have to buy an aftermarket filter later any way
james
james
u do know that ur going to only get as much air flowing through there as the smallest area so it doesn't matter how big of a whole u have there as long as the mass air sencer is the same size it's not going to make that big of a difference if anything put a fan on the part thatu are going to cut out it will act like ram air in a way and ur air will be pushed through instead of sucked through
i drilled holes into my 86's box, you could feel a little bit of a difference, im going to get a filter adaptor with the mariah cold air box, but fornow im livin 10,000 dollar dreams on 100$ budget...........cutting out the airbox makes the intake sound badass around 3k of so too...........
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
befarrer
Microtech
3
Aug 22, 2015 05:52 PM
JIMMY54
1st Generation Specific (1979-1985)
2
Aug 12, 2015 05:40 PM







