speedo cable can suck it!!
#1
Full Member
Thread Starter
Join Date: Sep 2006
Location: detroit
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
speedo cable can suck it!!
ok so i spent about 2 hours last night trying to plug in the speedo cable into the back of my cluster and no luck at all.
there is just not enough room for me to plug the cable in straight.
so what im wondering if i disconnect the other end of the cable (on the trans, or wherever it is) will it give me any slack to pull the cable out a little so i can plug it in the back of the cluster without mangling my arm/hand.
does anyone have any suggestions.
the only good thing that came out of this experience is now i can take out the gauge cluster in about 5 minutes. my hand hurts.
there is just not enough room for me to plug the cable in straight.
so what im wondering if i disconnect the other end of the cable (on the trans, or wherever it is) will it give me any slack to pull the cable out a little so i can plug it in the back of the cluster without mangling my arm/hand.
does anyone have any suggestions.
the only good thing that came out of this experience is now i can take out the gauge cluster in about 5 minutes. my hand hurts.
Last edited by saywhat??; 11-28-06 at 09:59 AM.
#2
Semper
iTrader: (3)
Join Date: Feb 2006
Location: Alabama
Posts: 1,354
Likes: 0
Received 0 Likes
on
0 Posts
ya mine took me about 10 minutes.....you just have to pull the cluster out far enough to plug it in.....i guess if you disconnected it from whereever it connects to it would give you some slack to work with....
#3
Lives on the Forum
Yes, unbolt it from the transmission (drivers side, about in the middle, around 45 degrees from vertical up high) then it's easier as you can actually pull it through enough to plug it in.
#5
Iraqi's Hate Me
Join Date: Nov 2005
Location: From: Phoenix\Stationed: Germany
Posts: 170
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by ROTARYROCKET7
connect the cluster first and the transmission last, i got fat hands and i cut my wrists up putting the cable in. But i got her done
Do er in da butt....
#6
Full Member
Thread Starter
Join Date: Sep 2006
Location: detroit
Posts: 60
Likes: 0
Received 0 Likes
on
0 Posts
cool. thats what i was thinking too but i wasnt sure if maybe the cable was secured at the firewall somehow and i wouldnt be able to pull it through a little bit.
thanks everyone.
thanks everyone.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM