snapped rear sway bar stud
#1
Full Member
Thread Starter
Join Date: Nov 2012
Location: alberta
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
snapped rear sway bar stud
So i have this little problem. I was putting on some Racing beat sway bars and as i was changing the rear one of the studs that hold on the bushing snapped.
Has this happened to anyone?
If so what did you do? Drill the piece out and weld a new stud on or can you pound it out and put a new one in?
Has this happened to anyone?
If so what did you do? Drill the piece out and weld a new stud on or can you pound it out and put a new one in?
#5
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Attachment 535488
Attachment 535494
I just answered my own thread. There is two bolts holding this plate on the frame which has the studs on in (press fit)
Attachment 535494
I just answered my own thread. There is two bolts holding this plate on the frame which has the studs on in (press fit)
Shows how long I haven't been back at that section of the car!
Thread
Thread Starter
Forum
Replies
Last Post
need RX7
2nd Generation Specific (1986-1992)
11
08-19-15 08:27 AM