alright i did a rhd conversion to my 86 rx-7 se, i took 2 s5 front clips and decided to convert everything over to s5 to make the conversion alot simpler. now i have ran into a snag. the rear chassis harness is being a real pain. i bought a usdm s5 rear harness figuring i could just extend a few wires and b good. well the bad part now is that after getting the harness i have found that the usdm ones and the jdm ones have different plugs for where it plugs into the fuse block. wat i am trying to figure if anyone has any input to maybe help me out. thank you for your time.

 

alright so i guess nobody is willing to help at all well this sucks

 

I've deleted all your bumps. Please be aware that bumps are not allowed in techincal forums.

You're not getting much of a response probably because no one knows.

Get your hands on a copy of the j-spec wiring diagrams (try asking in the Far East forum) and compare it to the North American FSM.

 

Too large a nightmare for a forum answer.