looking for advice for links etc.

i have recieved my engine back and getting it ready to drop in the hole as its completely bare.. i have put flywheel and will put clutch on and bottom half of inlet manifold connected the vacuum to oil squirters..

Question.. what are the o-rings for outside of the engine i have a packet taped to it so assume they are for some part..

does the engine mount that bolts to the side of the motor require washers?

what else can i put on before dropping it in?

 

Update** 2 small o-rings go im primary innjector holes

 

should get an Atkins video/dvd to assemble the engine (www.atkinsrotary.com)..Or go to www.rotarycarclub.com and ask Rotaryresurrection(Kevin) to kindly ask him to Send you his Tutorial on a Rebuild..they Took it out here due to Indifferences with the forum Owners and Kevin himself.

 

if it is the turbo engine the rubber o-rings goto the lower intake manifold for the coolant to turbo line.

 

Fsm!