s5 wastegate porting finished finally check it out
Thread Starter
Rotary Freak
Joined: Mar 2004
Posts: 1,575
Likes: 0
From: pennsylvania
s5 wastegate porting finished finally check it out
i finally got to finish porting my wastegate on my s5 t2 i just got back from vacation for a week i used a long carbide bur like they used on the write up on fc3spro.com tell me what you's think the first pic is when i was about 1/4 of the way done the rest are after i got done finishing it up and smoothed it all out do you's think it will stop the boost creep now or not
Not bad.
Grinding that **** was a PITA for me.
I ended up grinding a bit of the lip off to make a smooth exit towards the DP. I also did it a bit below where the flap/door sits so it is a bit open even when closed.
So far I boost 6psi natural. It's a great mod.
Grinding that **** was a PITA for me.
I ended up grinding a bit of the lip off to make a smooth exit towards the DP. I also did it a bit below where the flap/door sits so it is a bit open even when closed.
So far I boost 6psi natural. It's a great mod.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
Mar 28, 2017 03:30 PM
