so i had a little problem with my motor an over ported it. Broke 2 of my 3 side seals in my rear rotor. BUt the front was fine odd. But a guy on here said he would sell me s5 plates that are already street port. But i kow there will work but what about the knock sensor isnt it on the rear housing on a s5 an on the middle iron of the s4. or is it on the middle plate to.. let me know what il have to do to make it work

 

anyone

 

Knock Sensors, as far as I know, are on the housing and not on the plates.

You will be able to use S5 plates, but you will want to do some research on whether or not you will need to use some sort of blockoff plate here or there.

 

well caca lol im asking steve kahn but it takes a while for him my txts to go through to his phone cause the distance an it take for ever

 

On the S4 the Knock sensor is is located in the back of the center iron, that said there aren't many people that run one, so I wouldn't worry about using a knock sensor too much.

 

but if i dont use that wont it not start.

 

no it will start especially since its a s4 its dame hard not to get one to start the ecu dosent give a crap. and most dont runna knock sensor because when it goes into action your motor is prolly already fubared