S4 Vert / Coupe door interchange?
#1
Full Member
Thread Starter
Join Date: Jul 2004
Location: Townsend, MT
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
S4 Vert / Coupe door interchange?
I have an 88 Vert that needs a driver's door. Does anyone know if a door skin from a coupe will work, or am I looking at trying to find a local doner vert?
This thread SEEMS to say that I can take the skin off the coupe door, but there is some dissent: https://www.rx7club.com/showthread.p...ight=vert+door
No wrecking yards near me admit to having any sort of FC so I would have to buy a door from a fellow rx-7 club member and go pick it up, so I'd like to know for sure before I attempt this.
Thanks
Karl
This thread SEEMS to say that I can take the skin off the coupe door, but there is some dissent: https://www.rx7club.com/showthread.p...ight=vert+door
No wrecking yards near me admit to having any sort of FC so I would have to buy a door from a fellow rx-7 club member and go pick it up, so I'd like to know for sure before I attempt this.
Thanks
Karl
#3
Full Member
Thread Starter
Join Date: Jul 2004
Location: Townsend, MT
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Icemark
No, you can't use a coupes door panel without major sheetmetal work.
In the thread I referenced, you said
Originally Posted by Icemark
the skin is the same but there are some minor structural differences (like not having a window surround- and the mounting points for the fixed window"
To clarify, my door looks like it has rust holes near the bottom, so I was looking to replace the sheetmetal on the whole door, but I could just replace the lower door skin, if even that part is compatable.
Karl
#5
Former Moderator. RIP Icemark.
Originally Posted by karlm
I was afraid someone would say that
In the thread I referenced, you said Did something change your mind, or am I reading that wrong?
To clarify, my door looks like it has rust holes near the bottom, so I was looking to replace the sheetmetal on the whole door, but I could just replace the lower door skin, if even that part is compatable.
Karl
In the thread I referenced, you said Did something change your mind, or am I reading that wrong?
To clarify, my door looks like it has rust holes near the bottom, so I was looking to replace the sheetmetal on the whole door, but I could just replace the lower door skin, if even that part is compatable.
Karl
See you would have to re-form the rear panel edge where the door frame is on the coupe, but not on the vert.
So that is why I said major sheet metal work
A coupe door would probably bolt up just fine... its getting it to match to the top and existing vert supports and A pillar.
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM