Hey all I wanted to know the size and thread pitch of both levers. Thanks.

Santiago

I searched a little but I just found threads about aftermarket shift **** and if they would fit or not. meh.

 

If your referring to the thread at the top where the **** fits...On my S5 it is a 10mm x 1.25 pitch

Don't know if the S4 is the same or not.

 

I think I saw a post about s4 being different.

 

S4 and S5 are differenty yes. I ahve the S4 leverrs here and I have an S5 available but not right now. Thanks for the info. I will just take my S4 lever to the hardware store and try all the nuts I can.

 

You still may not find the right nut to fit it, the tap&die set that I have has 10mm 1.0 pitch and 1.5 pitch but not 1.25 pitch. I determined the correct pitch using a thread pitch gauge.

This is the second 'rare' thread that I have found on the S5, the other is the TPS adjustment screw, it is finer then any available bolts that I have seen. I went looking when I dropped the small lock nut, couldn't find it for days, eventually fished it off the intake manifold with a magnet....that was lucky!

 

S4 shifter lever has threads of M12 and thread pitch of 1.5

 

I want the s5 shifter for my s4. How can I make this possible?