Hello, I have a s5 turbo motor and I was wondering if I can use a s5 non turbo engine harness? If I can use a non turbo harness what needs modified so it will work. Also I am using haltech e8 and was wondering if there is any sensors that I can get rid of or any thing else that can go. I already know I can get rid of the mass air flow. I am also using the haltech plug and play for the engine wiring harness.

Thanks

 

oh man...

then why on earth are you asking about using the stock na wire harness?

and there is no plug and play haltech harness unless someone else already made it for you. in that case, you should already know what you need and dont need.

 

The haltech plug and play is not a wiring harness it is were you plug the factory harness in to. So you can use the factory engine wiring harness. I guess I said it wrong.

 

ehh...are you sure about that. ive never heard of anything haltech using a stock wiring harness. it usually just uses a blank, unterminated harness.

 

Here is a picture of it.

 

hmm...ive never seen one of those. i'm assuming you will need the tps, coolant temp sensor, intake temp sensor, a 3bar or gm map sensor and that should be it. thats all i needed with my haltech. i would rather use the full haltech harness and buy new sensors. they arent very expensive. i have some left overs that are new if you go that route.