On the "Monitor" mode what is your thrtl % reading when your not pressing on the gas. Its not supposed to be at 0% right? How do you have your tps set? Wich hole on the tps are you using (looking at it from front of car; left, middle, or right hole?

 

also i have a tps with only 1 plunger

 

please sombody post and answer to my q...

 

come on guys, help me out

 

i dont want to go thourgh the led light tester thing cause i have and s-afc. that should the thrtl% be at when not pushing the gas??

 

What oops, shoud be the thrtl % when not pressing the gas

 

If I had one and knew I would help you out man. I can help put this back up top though What part of Tampa you in?

 

You still have to have your TPS set properly, whether you have an S-AFC or not. Zero would make sense...

 

Yes it should be at 0% during idle.

 

Hmm ok, so it should read zero when im not pressing the gas right, (on the S-AFC that is) Ok ill give it a shot and see what happens. Ryde or Die; Im In town -n- country part of tampa, right off of hillsborough ave.

 

thanks allstyle

 

mine reads 0 (or really really close to 0), but i've got the dual plungers.

john

 

OK

Dual "plungers" as you call them are on S5 cars it's a full range TPS. The single "plunger" is on S4 cars.

Go to the main menu and hit ect. go to voltage check. Check your tps from here it should read as close to 1v as possible no % needed. And yes while idling the throttle % should be about 0, however I think the SAFC learns what the range is so if your TPS is way out of whack it might give some different numbers.

In addition how about giving the forum members more than 10 minutes at a time to answer your question.

 

I have an s4 and with the car off the TSP give the s-afc a reading of ~30% even though the TSP voltage is set to ~1v

 

Ridgetech. Reset your safc.

 

Well, huh I just went out to my 91 TII and the SAFC says 1.15V and 3.3%. Now that is just sitting there not idling and cold. I have the cold start stuff removed so that should not matter. Should I readjust that TPS till it is 1V ?

James

 

hmmmm thanks for the info

 

Yes

set the TPS voltage to 1v then reset the SAFC using the initialize function.

 

Ight coo. You over by Webb middle school then right? I play ball there every once in a while. Nice to see an Rx7 man nearby.

 

Instead of using a volt meter to adjust your TPS setting use your SAFC. Put it on sensor check and you can see the voltage. Adjust it to 0.955. It works for me.

 

sweet, everything is in order now. Now just to set everything else. can any one help with that. hi and lo thrtl % and hi and lo thrtl % through out ne settings? Yea Ryde or Die i play ball at jackson springs park. ill swing by webb one day and show you the rx and gsx.

 

My low thottle is 30, high thottle 90. On monitor mode at idle, what is evey ones air flow? Mine is 13.8% to 14.7%, she idles real good around this % of air flow..

 

Ight cool. I know a few people that got FCs too.