i have an 88turbo 2 10ae
the primary injectors were cloged so i replaced them with some i bought the kid said they were profesionaly cleaned
it made the car actualy run but now it feels like it might only be running on one rotor in low rpm,s i have to ride the clutch to keep it runing
i cant figure it out i even rewired on of the injectors that was haggered.
im new to fc's
and really have no clue of the problems..
the car wont boost anymopre also.when the secondary injectors come on and i let off the gas it pops a huge flame..i dont know if thtas a sighn of something or what.
what could be the problem

 

that means u are burning a lot of fuel just over loading. does your car flood? is it hard to start after a while like even hours or days? well it might be your ecu... it can be fouled or just bad. is it at low rpms of high rpms??? is it the secondary injectors or primary injectors? need these answers to make right answer..

 

sry ya u said its ur primaries well it could be that on ur ecu its holding the primaries open for too long dumping full and overloading which makes it run rich and can cause flame pop. is ur intake burnt at all?

 

not sure i just know that when i first replaced the injectors it ran but only felt like it was on one rotor. but when the secondary injectors kicked on and it got into boost it took off and ran good.so pulled the injectors out again and rewired them and what not, it wont get into boost anymore and it still runs like ****