Reverse gear grinding
11-16-06, 12:30 PM
#1
Junior Member
Thread Starter
Join Date: Nov 2006
Location: Los Angeles
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Reverse gear grinding
When i go into Reverse my Gear keep grinding and it wont reverse.
A Lil Help Please.
i move back and forward thru Nuetral. I swing hard to End. I tested alot
but it keeping grinding going into reverse.
A Lil Help Please.
i move back and forward thru Nuetral. I swing hard to End. I tested alot
but it keeping grinding going into reverse.
11-16-06, 12:33 PM
#3
your clutch is dragging then, reverse is the only gear with no syncro so if the transmission input gear is rolling away(clutch grabbing) then it won't go into gear. you could have a clutch hydraulic issue, worn clutch or throwout arm issues - the pivot for the throwout arm likes to snap off on FCs... could also be a less pronounced issue like pilot bearing failure grabbing the input shaft and keeping it turning, in any case the transmission needs to come out to diagnose the problem.
11-16-06, 12:33 PM
#4
The mystery of the prize.
Is your clutch disengaging fully? Clutch to floor? Anything on the floor? A floor mat or anything in the way preventing the clutch from going down all the way?
Keep in mind that reverse on these cars does not have a syncro, so if the input shaft is turning and the car is sitting still, its going to grind when you try to engage reverse.
Karackakakaka ya beat me !
Keep in mind that reverse on these cars does not have a syncro, so if the input shaft is turning and the car is sitting still, its going to grind when you try to engage reverse.
Karackakakaka ya beat me !
Thread
Thread Starter
Forum
Replies
Last Post
MILOS7
3rd Generation Specific (1993-2002)
2
10-09-15 02:19 AM
