Restrictor Pill
08-16-02, 03:42 PM
#1
Restrictor Pill
Is there a restricter pill in the wastegate line on an 88TII?
If so, can I remove it and still stay at about 8 or 9 PSI with the following:
2.5 inch full turbo back exhaust
TID
Cone Filter
Ported wastegate
I would rather not put the cat back on it if possible.
If so, can I remove it and still stay at about 8 or 9 PSI with the following:
2.5 inch full turbo back exhaust
TID
Cone Filter
Ported wastegate
I would rather not put the cat back on it if possible.
08-19-02, 04:04 PM
#3
It is a small bead that is used to restrict the flow in a vaccum line.
I believe ther is one in the wastegate actuator line of the Series 4 TII. I think that if I remove it, it will increase the pressure in this line therefore opening the wastegate at lower pressures.
Can anyone verify this??
I believe ther is one in the wastegate actuator line of the Series 4 TII. I think that if I remove it, it will increase the pressure in this line therefore opening the wastegate at lower pressures.
Can anyone verify this??
08-19-02, 04:15 PM
#4
Round&Round not Up&Down
Join Date: Aug 2001
Location: West Bloomfield, MI
Posts: 2,805
Likes: 0
Received 0 Likes
on
0 Posts
I have a pill, but it's about 1" from the boost sensor which goes to my BOV, Boost gauge, and ends at my UIM.
I do not have one in my wastegate line.
I do not have one in my wastegate line.
Thread
Thread Starter
Forum
Replies
Last Post
JDyer
3rd Generation Specific (1993-2002)
5
02-04-02 09:13 PM
rotorhead46
2nd Generation Specific (1986-1992)
2
01-07-02 10:30 AM