removed air pump and acv
#1
Rotary Enthusiast
Thread Starter
removed air pump and acv
Ok so i removed the air pump, split air pipe and i think its called the acv (the one that has a rubber pipe with a silencer on it and purges air from air pump). I made block off plates ,put on the dual alt pulley, and started it up. Ran fine,drove fine, but my concern is i can hear my stock BOV really loud now. I was only at 5-6psi. My question is, is this normal or is something not right on it. I love the sound of my BOV now but i like my motor to stay running even more. Thanks
MODS:custom intake pipe, Apexi gt spec DP,Apexi Gt spec exhaust, No cat, and FCD, Boost guage
The valve at bottom of pic is one of the ones i removed and blocked off
MODS:custom intake pipe, Apexi gt spec DP,Apexi Gt spec exhaust, No cat, and FCD, Boost guage
The valve at bottom of pic is one of the ones i removed and blocked off
Last edited by florotory; 02-18-10 at 07:03 PM.
#4
Rotary Enthusiast
Thread Starter
What would it sound like if my BOV wasnt working at all? Lets say it wasnt purging air at all would the same noise occur? I just dont wanna mess up my Turbo or motor. Thanks again
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
12abridgeport
1st Generation Specific (1979-1985)
2
08-17-15 06:28 PM