Removal Of OMP to do PRemix.. or just unplug
#1
Full Member
Thread Starter
Join Date: Mar 2005
Location: Fort walton beach FL
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Removal Of OMP to do PRemix.. or just unplug
Well, if my engine is in Limp Mode due to Failing OMP and i dont have MUCHO$$$$$$$$$$$ to replace the OMP what should i do to disconnect it and run a premix... anything important i need to take note of
#4
Eet fase
iTrader: (49)
Join Date: May 2002
Location: Lexington, SC USA
Posts: 1,759
Likes: 0
Received 0 Likes
on
0 Posts
There is a for-sale section on this forum and of course there is always eBay. I failed to mention that in order to get your car out of limp mode you have to have working unit plugged in whether or not you chose to premix.
#5
Just run premix, get rid of that piece. Just plug a good omp into your loom and zip tie it out of the way to get around the limp mode problem. The only other suggestion I have so you dont have to keep the OMP in the engine bay is, you may be able to connect pin 2f on the nr TPS and pin 2a on your OMP. Basically the omp and the narrow range tps pin 2f lock into the same ic on the board, so this should work. I myself would just plug it in, premix, and zip tie the bitch out of the way. Good luck.
#6
Full Member
Thread Starter
Join Date: Mar 2005
Location: Fort walton beach FL
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
I do business with this guy who owns atlantarx7.com i forget his name but he has been a lot of help, ill probalby just order it from him . . . he guarantees all his used parts and wont rip me off..
Thanks again..
so i do need one regardless huh?
Thanks again..
so i do need one regardless huh?
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM