rebuild question
#1
Junior Member
Thread Starter
Join Date: Feb 2004
Location: VA
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
rebuild question
doing my first rebuild and i was wondering if the side housing can be machined where the rotor spins at and the service manual doesnt really say, and is there anything to the rotor housings and side housing that have to be prepared i.e cylinder honing for a piston engine.
thanks
rat
thanks
rat
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM