Rear Hub/Bearing housing
#1
Rear Hub/Bearing housing
So taking apart the rear end on the car, I tried to get out the screws holding the rotors on and I broke off not 1 but 2 impact screwdriver bits in the screws... one came out without any problems ... the other... well lets just say, I had to drill it out. Unfortunatly I managed to get off center (not my fault metal made me do it) and now I think I may have damage the threads in the screw holes ( when I say may have I mean unless the hand of god stopped me I know I did). But anyways so my question is this...
How critical are the screws? Will one work since the wheel holds on the rotor too by being tightened on the hub/rotor? Should I just replace the hub? Anyone have a Hub for sale if this is the case?
Thanx for any advice
How critical are the screws? Will one work since the wheel holds on the rotor too by being tightened on the hub/rotor? Should I just replace the hub? Anyone have a Hub for sale if this is the case?
Thanx for any advice
Thread
Thread Starter
Forum
Replies
Last Post