Racing beat holley, 12A distributor,MSD
Thread Starter
Junior Member
Joined: Jan 2006
Posts: 6
Likes: 0
From: santee, ca. 92071
Racing beat holley, 12A distributor,MSD
I need to know if I can run 1 MSD 6A ignition or do I need 2 ???. Also whould I wire it up the same as a standard electronic system??? 
I run one with the leading, leave the trailing stock.
I find its accually ALOT better to use the FC leading coil and stock J-109 ignitor. It worked MUCH BETTER than the MSD setup. I tried using the MSD megnetic pick-ups AND the White wire trick, using the stock J-109 ignitor.
I think the MSD would work best with a direct fire application, bypassing the dizzy. After all, the MSD just acts as a amplifier.
Theres a guy here that runs 1 MSD for each system, 1 for leading, 1 for trailing. He was having some problems with the trailing last I heard.
I find its accually ALOT better to use the FC leading coil and stock J-109 ignitor. It worked MUCH BETTER than the MSD setup. I tried using the MSD megnetic pick-ups AND the White wire trick, using the stock J-109 ignitor.
I think the MSD would work best with a direct fire application, bypassing the dizzy. After all, the MSD just acts as a amplifier.
Theres a guy here that runs 1 MSD for each system, 1 for leading, 1 for trailing. He was having some problems with the trailing last I heard.
Last edited by Alak; Feb 26, 2006 at 09:36 PM.
Thread
Thread Starter
Forum
Replies
Last Post
acha3
2nd Generation Specific (1986-1992)
7
Sep 6, 2015 08:14 AM
