I ordered some stainless steel oinl injector lines and I was putting them one when I noticed that I couldn't tell it the holes from the injector and inside the lines were lining up. I also didn't know which lines were supposed to go to which holes on the pump, so I was wondering if it even mattered and if someone knew which line goes to which hole? Also, how do i know if the holes inside the ring of the line match up with the hole for the injector?

 

The holes do not have to match up, they use banjo bolts, oil flows around the whole bolt and the banjo fitting feeds the oil. The copper crush washers seal the oil in, so if the hole is off, it don't matter, oil will find its way there.

Start off with the shortest line and hook it up to the nearest banjo bolts on the omp and manifold, the rest you'll figure out.

 

Thanks, I took your advice and got it all hooked up. I appreciate the help.