I'm thinking about a GT28RS with a tial wastegate. (Supporting mods already in place i.e. fmic, boost controller,warlboro pump, aeromotive fpr)

My main question is .. do I need to get a custom manifold made for this turbo? Or is there something prefabbed already? If so where do I get it?


My goal is to break 350whp .. be streetable and trap about 116ish. Can I do this on the BNR or should i just say screw it and go the custom route ?

Also I'm considering 720/1300 to run with the setup .. any problems with this if i have a proper engine management system?).

 

waaaaaay tooo small
u will need like 4 GT28s to make power lol

u mide as well go with a hybrid instead of disco potato

and to make 350 i think you shoudl only need 4x 720cc

 

after more research i want to do a gt35r ... but who makes a manifold for that ? or do i have to buy a prefabbed one and swap off the flange ?

 

Check out the single turbo forum, there are plenty of builders there. I got mine from www.turblown.net I suggest a t4 flange.