2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

1500-2500 rpm hesitation...

Thread Tools
 
Search this Thread
 
Old 04-10-07, 03:02 PM
  #1  
Full Member
Thread Starter
 
nathan214's Avatar
 
Join Date: Dec 2006
Location: Iowa
Posts: 78
Likes: 0
Received 0 Likes on 0 Posts
Angry 1500-2500 rpm hesitation...

When i am just driving normally, bout a mom in mini van pace, ill get anywhere between 1-2500 rpm and there is a hesitation, then after that its fine...it is really pissing me off and i have no idea what the problem is.
Old 04-10-07, 03:07 PM
  #2  
Rotary Enthusiast

iTrader: (1)
 
Spectator's Avatar
 
Join Date: Aug 2005
Location: Canada
Posts: 1,315
Likes: 0
Received 0 Likes on 0 Posts
Primary injectors are not working properly?

You could try and clean them?

Any other suggestions?
Old 06-05-07, 06:13 PM
  #3  
Junior Member
 
jgibbs22's Avatar
 
Join Date: May 2007
Location: California
Posts: 25
Likes: 0
Received 0 Likes on 0 Posts
Hey Bro:

I have a 88 convertible NA that has the EXACT same sounding problem. Whenever I am just crusiing down the road somewhere around 2500 rpm the car bucks about once or twice every minute, but continues running ok. Have you had any luck solving this? I am going to put new plugs, wires, filter, and all new cats in later this week. I will post if I have any luck.
Old 06-06-07, 05:11 PM
  #4  
weeeeeeeeeeeeee

 
splatterbass's Avatar
 
Join Date: Oct 2006
Location: vancouver canada
Posts: 33
Likes: 0
Received 0 Likes on 0 Posts
just resolved the same thing in mine.
turns out the tps was out of adjustment. and the timing was out.
Old 06-07-07, 09:03 AM
  #5  
Junior Member
 
jgibbs22's Avatar
 
Join Date: May 2007
Location: California
Posts: 25
Likes: 0
Received 0 Likes on 0 Posts
Splatter:

Any chance you could pst or link the method you used for adjusting the TPS and timing? I have that gactory manual and it says to use some wierd checker light for the TPS...
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
dona1326cosprings7
1st Generation Specific (1979-1985)
4
10-29-15 06:47 AM
LongDuck
1st Generation Specific (1979-1985)
12
10-07-15 08:12 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Einheri
Single Turbo RX-7's
14
10-07-15 12:23 PM
musker
New Member RX-7 Technical
1
10-01-15 05:58 PM



Quick Reply: 1500-2500 rpm hesitation...



All times are GMT -5. The time now is 03:21 AM.