questions about my new wideband
#1
tom port.. AKA streetport
Thread Starter
iTrader: (6)
Join Date: Jan 2005
Location: ludlow, pa
Posts: 4,659
Likes: 0
Received 0 Likes
on
0 Posts
questions about my new wideband
first of all its the one from injected performance hes(marty) selling on the forum, the LC-1 cable with the XD-1 guage! when i did the free air callibration today it didnt heat up like i thought it should of. shouldnt it heat to the point of burning my hand? also shouldnt it heat up FAST, i let it sit there for a minute or so and it didnt even get warm.do i not have the heater ground in a good enough spot or maybe the 12volt doesnt have a strong enough current. could this be my problem?
#3
tom port.. AKA streetport
Thread Starter
iTrader: (6)
Join Date: Jan 2005
Location: ludlow, pa
Posts: 4,659
Likes: 0
Received 0 Likes
on
0 Posts
not yet as i dont have a anything to check it. is tis my first step? the tools i need are at work so im getting a heads up so i know what to check for. should it heat up quickly and hot?
#5
tom port.. AKA streetport
Thread Starter
iTrader: (6)
Join Date: Jan 2005
Location: ludlow, pa
Posts: 4,659
Likes: 0
Received 0 Likes
on
0 Posts
no because im only using it to read my a/f readings im using a safcII so the analogs are just grounded. i just hooked up all the grounds and capped off the analog hot wires. im thinkin i need to find a better 12v source, what should i use?
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM