knak

ok i think im retarded. i have a s5 shift lever and **** that im going to try to put in my s4tII. dose anyone know how do this. thanks

1987RX7guy

iTrader: (3)

Remove old shifter ****/lock nut. Lift shifter surround out. Unbolt old shifter. Drop in new shifter lever with new bushings(almost everyone has dead bushings) place shifter surround back over it and thread the new **** on.

Finished.

DoriftWolf

with pics

http://www.mazdatrix.com/faq/shiftbsh.htm

just did it yesterday... it's easy

knak

ok cool.
problem is that my shift lever dosent have that cap thing around it, and i dont know what its called. umm how/ can i take it from my old shift lever?

RETed

Pay a shop to do it for you.


-Ted

Icemark

You don't... you buy a new boot/cap and put it on the replacement shifter.

1987RX7guy

iTrader: (3)

If you're in a pinch just slit the old one on the side and put it on for temporary use ONLY.

ultrataco

iTrader: (2)

sorry to bring up (and jack) an old thread, but I also do not have the cap thing. When I changed my shifter bushings, I bought a new inner boot, but the metal part wasn't on it, and mazdatrix doesn't even sell that part. My shifter had the metal cap, but the rubber boot part had been cut/ ripped off for some reason. I just put the inner boot on by itself. Should I put the inner boot on top of the metal thing?

this is what i have:

Icemark

yes, or you can replace the metal ring found on the older shifters with just the new part