Question about an engine swap.
#1
Full Member
Thread Starter
Join Date: May 2006
Location: Ft. Myers Florida
Posts: 64
Likes: 0
Received 0 Likes
on
0 Posts
Question about an engine swap.
How hard is it to put a 13b 4 port with a 12a front housing into an FC?
Can I just switch the oil pan and drop it in? It's coming out of an FB. Also will it bolt up to my trans? Thanks in advance.
Can I just switch the oil pan and drop it in? It's coming out of an FB. Also will it bolt up to my trans? Thanks in advance.
#3
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
The FC mounts engines on the center iron. The earlier engines mounted at the front cover. It's likely that your engine doe not have the mounts in the center iron needed to mount in the FC. So you would need to make custom mounts off of the FC subframe to connect to the mounts at the front cover.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM