PROBLEM: 87 FC - License Plate wide for rear bracket
#1
Junior Member
Thread Starter
Join Date: Jun 2004
Location: Western Australia
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
PROBLEM: 87 FC - License Plate wide for rear bracket
Hi all,
I'm from WA, Australia and I've just imported an '87 FC from Japan. The problem is the standard license plates are gonna be too wide (372mm) for the brackets in the rear tail light assembly. Are there any FC owners out there with this same problem? Should I try trimming the plates (is this legal?) or should I try cutting into the plastic plate holder assembly?
I'm from WA, Australia and I've just imported an '87 FC from Japan. The problem is the standard license plates are gonna be too wide (372mm) for the brackets in the rear tail light assembly. Are there any FC owners out there with this same problem? Should I try trimming the plates (is this legal?) or should I try cutting into the plastic plate holder assembly?
#4
I'm a boost creep...
Join Date: Jan 2002
Location: Auckland, New Zealand
Posts: 15,608
Likes: 0
Received 8 Likes
on
8 Posts
Some cars imported from Japan have that problem with our plates too, since Japanese plates are quite small. Usually the edges of the plate are bend outwards to make it fit, since it's technically ilegal to modify the plate by cutting it. Personally I'd just cut it.
Thread
Thread Starter
Forum
Replies
Last Post
gabescanlon
3rd Generation Specific (1993-2002)
9
08-22-15 08:31 PM
rx8volks
Canadian Forum
3
08-20-15 10:24 PM