Presilencer blues.
#1
Senior Member
Thread Starter
Join Date: Feb 2004
Location: NYC/Stony Brook Univ.
Posts: 702
Likes: 0
Received 0 Likes
on
0 Posts
Presilencer blues.
I just ordered a borla batback off jc whitney. I had to take off the stock catback due to my mechanic litterally blowing my drivers side muffler (long story)....
anywya so i kinda broke one of the two presilencer bolts! what should i do?
a. get a muffler shop to weld the ****** right to the cat back?
b. leave it, one bolt is good enough?
c. ____________
Thanks!
Jahan
anywya so i kinda broke one of the two presilencer bolts! what should i do?
a. get a muffler shop to weld the ****** right to the cat back?
b. leave it, one bolt is good enough?
c. ____________
Thanks!
Jahan
#3
Lives on the Forum
iTrader: (7)
You broke that bolt? Damn, that takes some work. I broke the stud on the exhuast man, and it took some major work, and its not as sturdy. Anyway, I wouldn't run with just one bolt. I did that (alhtough it was closer to the engine) and I would literally vaporize a gasket with RTV650 in a day or two. Figure out a way to get the bolt back on.
Thread
Thread Starter
Forum
Replies
Last Post
jeremyferguson4444
1st Generation Specific (1979-1985)
8
09-19-15 01:27 PM