power steering problems
#1
Junior Member
Thread Starter
Join Date: Jun 2007
Location: lompoc, ca
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
power steering problems
Ok... I am suffering from a problem. This is my second rx7 (my first was an 87 2x2). The engine is out because the previous owner is a... well... he doesn't know rotaries. I am slowly putting things back together and I finally got to power steering. And the pulley is missing parts. I have done some reading and I understand there are two different types of power steering. One is speed sensor and the other is rpm sensor. I have an 86 gxl. I am getting everything together to either replace the pulley or just switch over to manual steering but right now... I dunno. Advice rotary gods?
#2
Junior Member
Thread Starter
Join Date: Jun 2007
Location: lompoc, ca
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone know where I can find a new or used power steering pulley? I have been searching frantically looking for one so I can just continue the process of putting the engine back into the car and I don't want to try to install a manual steering rack.
#4
Rotary Enthusiast
iTrader: (1)
Join Date: Nov 2012
Location: bloomington, mn
Posts: 1,100
Likes: 0
Received 0 Likes
on
0 Posts
I have this exact same car and pump. shoot me a pm so I am reminded about it, and I will get you all the dimensions of my pulley. Then hopefully you can find one that will fit at the junkyard or something. My pump is currently out of the car so this is no problem.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
LunchboxCritter
2nd Generation Specific (1986-1992)
15
01-03-16 04:11 PM