Power Steering leak from Hell
#1
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: California
Posts: 1,114
Likes: 0
Received 0 Likes
on
0 Posts
Power Steering leak from Hell
I just replaced the "Pressure" hose, and a small "suction hose", on my power steering system yesterday in hope of fixing my leak, but it got worse.
Ill make this short, everything is tightened up properly,and power steering works great no problems, but im seeing a bigger puddle of p/s fluid on the ground( on the DRIVERS SIDE OF THE ENGINE COMPARTMENT) when the car sits over night then before.
The pressure hose is not leaking anywhere , dry as a bone, and same applies for the suction hose I also replaced. QUESTION IS....where else could it be leaking from?
Ill make this short, everything is tightened up properly,and power steering works great no problems, but im seeing a bigger puddle of p/s fluid on the ground( on the DRIVERS SIDE OF THE ENGINE COMPARTMENT) when the car sits over night then before.
The pressure hose is not leaking anywhere , dry as a bone, and same applies for the suction hose I also replaced. QUESTION IS....where else could it be leaking from?
#5
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: California
Posts: 1,114
Likes: 0
Received 0 Likes
on
0 Posts
actually one of my oil cooler lines IS leaking but only like 1 drop a day so im not concerned about that right now plus engine oil level is still full, but im sure it was p/s fluid because ive had to refill it again due to it being low....? im thinking maby the steering rack?? or possibly the p/s pump itslef is leaking?
#6
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Jun 2007
Location: California
Posts: 1,114
Likes: 0
Received 0 Likes
on
0 Posts
I saw a "seal" kit to completley rebuild the power steering rack for about $125 from Mazda, is it worth it? or should I get an after market rebuilt steering rack for a slightly higher price?
#7
Full Member
iTrader: (1)
Join Date: Jan 2007
Location: St. Louis
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
There are two small o-rings under the resevoir that could be old, dried out and leaking. Under the resevoir, there are two 12mm bolts that you could try and tighten. They are directly under the resevoir. Hope this helps
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM