power locks
12-19-05, 01:30 AM
#1
Junior Member
Thread Starter
Join Date: Aug 2005
Location: St Louis Mo.
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
power locks
Does anyone have a wiring diagram for the power lock switch. Im trying to add aftermarket actuators to one switch. I have a factory switch with 6 wires coming off of it 2 blue/black, 2 black, red, and green. I could use any help that i can get, trying to figure it out is hurting my brain.
12-19-05, 11:07 AM
#3
Former Moderator. RIP Icemark.
You can not add power locks to the factory switch without adding additional parts.
At the very least if you had a car already with factory power passenger's door lock, you could just add a actuator and controller for the drivers door.
If you wanted to use the factory switches, you could use a factory switch run to a DEI pulse generator and from there to a couple of relays, and then to aftermarket actuators for power locks.
At the very least if you had a car already with factory power passenger's door lock, you could just add a actuator and controller for the drivers door.
If you wanted to use the factory switches, you could use a factory switch run to a DEI pulse generator and from there to a couple of relays, and then to aftermarket actuators for power locks.
Thread
Thread Starter
Forum
Replies
Last Post