crossbar17

where can i get these pineapple racing 6port sleeves?
how well do they work? hP gains etc etc
how do u install them? simply take TB off and intake manifold

i have a 1988 SE n/a

crossbar17

also, with the 6port sleevs will my ports be open all the time?? or will i still have to wire them open? if they are open all the time can i remove my actuator pods

Node

iTrader: (1)

If I understood you right, you want to know where you can buy them
http://www.pineappleracing.com/Prod-pr6pi.html

crossbar17

ok thanx and also.....with the sleeves do i remove the 5th adn 6th port actuators or do i still need to mae them functional i.e. wire them open etc... etc...

also how do my 5th adn 6th ports open, its and 88 SE and i know it by exhaust back pressure, but does it use the tube coming off the cat to supply that backpressure or not??


thanx again all

HAILERS

Crossbar, it uses the tube coming off the cat. I wrote a answer and a method in the other post that you wrote. Three bucks or less to get them working.

Max7

You can still use the actuators or remove them, your choice, some low end may be lost, hehe
I installed a set last week, to bad its winter, won't find out till spring how they work.

crossbar17

so if i use the pineapple racing sleeves i can take my 5th and 6th actuator pods right off correct?? just take them off so there is nothign on that side of the engine?? or is it best to just wire them open with the pineapple racing sleeves instead of old sleeves??

pp13bnos

iTrader: (1)

The best way, would for you to leave the actuators on there, and put the Pineapple sleeves in there, while making shure they work. Good low end, and 6-8hp more up top. CJ