I'm needing a picture(s) of a 87 TII, stock, with the upper intake manifold off, but everything else intact. Reason is, I just picked up a TII that had a PD failure and fried a bunch of lines. I need to know where each piece goes. And rather than guessing and checking a few pictures would help me greatly. I'm looking for a picture similar to this, but in good condition.......

 

Bump

 

There is not as much there as you might think by looking at it. The 4 oil injectors plug into a "spider" that goes to the larger vaccum source on the back of the TB. The nipple that is on the lower intake manifold right where the maniflod meets the block goes to one of the smaller nipples on the back of the TB.

 

It might make your life a little easier if you simply removed all that stuff, instead of trying to repair it "back to stock"...?

I'm not sure what your 'goal' is, but now might be a good time to install some block-off plates and rip out the rats nest...

Kevin Lander's website has a decent write-up with pics...

 

ugh, what a mess. I'd go crazy looking at that if it was my car. heh.. I'd be breaking out the steel whool and thermal paint

 

You're looking at a job which the local Mazda dealer quoted me $5,000 to fix.
Good luck on getting all the answers here.


-Ted

 

Can you download and run a fairly big power point file if I PM it to you?

 

Yeah I have Powerpoint.

 

Honestly, that happened to me as well....(I didn't buy one that way)...and the cheapest fix was to take my engine and everything salvagable out of the burned car, and buy a car with a bad engine and good wire harness and make 1 good car. That went from $5,000 for me, to about $1,300.

 

Good. Check your messages, and give me a reply when you get a chance.

 

Got the file, I'll check it at work. Thanks again