Does anyone know where I can source the s4 t-stat spacer (the one that goes under the t stat neck) that originally came with the paxton s/c kit? I have the one for the S5, but it won't fit. The part # is 15N018 (not 15N018-1, thats the one I have).
I have searched some old threads as well as some sites of forum members who used to have this setup, but no clue as to who if anyone continues to support them. All I can find is this crappy pic- so here goes:

 

early am bump- gonna see about making what I got work... got a date with a gasket & a drill press tomorrow & see what happens...

 

Here is the s5 t-stat spacer with holes marked on both sides where I need to drill to make it fit the s4 block. The yellow arrows mark where the t-stat neck will mount to, (top surface of spacer) and the red arrow shows where I will have to drill and tap a hole (much like the one just below it) for a countersunk allen head bolt to which will go into the block.

My question is- (sonicrat, are you out there)will this still be enough of an offset to clear the blower housing?

Thanks- I know this is a pretty obscure question, cause not a lot of guys have gone the paxton sc route.