i just finally got my harness through the fire wall and hooked it back up to the ecu..at this point i ran it all under the ABS and straight towards the oil cooler along the "side wall" of the engine bay. i can see where most of the clips connect to but im concerned about the best way to route the harness.. can someone post a general path it takes? or does someone have a pic that would help? does it run under or above the rats nest? any help is appreciated...so close to getting the car running and im very anxious

 

somebody..anything

 

It runs up to the midpoint of the passenger siderail, then up into a bracket on the water pump housing (water filler neck), down and across the front iron, and finally on the inside of oil filler neck & under the emissions solenoids.

 

thanks! under or over the rats nest

 

In front of it, under it and partially over it (fuel injector plugs, O2 sensor).

The Yellow path shows where the main wire bundle goes.