a pair of unrelated questions that need answers ASAP
#1
kill it with BOOMSTICK!
Thread Starter
a pair of unrelated questions that need answers ASAP
Well, okay, only one does, but the other would be nice. The important one first: What size is the O-ring that goes on top of the fuel injectors (s5, but I assume that they are the same across the board)? Second, does anyone know where I can get dimensions of the rear subframe and diff mounts (the one's made out of delrin, being that I want to make them out of aluminum)?
Thanks!
Thanks!
#2
Full Member
Join Date: Aug 2003
Location: Auburn, Washington
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Well, to answer the first question, if you go into an injector shop or your average tuner and tell them you need some injector O rings....they will have them. They are pretty much all standard.
As for the 2nd, you could try jacking the car up and measuring them? Other than that, I have no clue.
As for the 2nd, you could try jacking the car up and measuring them? Other than that, I have no clue.
#3
kill it with BOOMSTICK!
Thread Starter
Right-o. Got the o-rings, no problems there. The problem, though, is that I can't get the exact diameter measure with the metal plate on the bottom of the mounts, and I want a setup where the aluminum is press fitted in. Thanks for the help!
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM