Ok, so what size are the banjo bolts that hold the OMP lines on? The OMP thread has gotten me slightly paranoid about my OMP system, and I just wanted to go over the whole thing and make it new.

The master bolt list says the following:

OMP/MOP: N/A, 10mm x 1.0 bolts
TII, 10mm x 1.25

Oil Injectors: N/A, M10 x 1.0
TII, M10 x 1.25

Oil Injector Lines: NA: 10mm x 1.25
TII (some) : 10mm x 1.00

But i thought that the head on the banjo bolts that connect the OMP lines to the OMP was 10mm, not the shaft. Can anyone confirm the diameter of the shaft of the banjo bolts so I can get the correct size crush-washers? Thanks!

 

Ok, they are M8 x 1.25. Are they the same size as the ones on the oil injectors themselves?