Does anyone know where I can find a Kit for the oil lines leading from the "block" to the Turbo and return line?

Thanks,
Steve

 

I dont know about finding a specific kit for it. But you can make the oil lines.. its not hard. I can do it for you if you buy the materials. Also, I have a oil feed line for a turbo in -3 ss line thatll fit a aftermarket turbo.

 

I have the lines for the turbo, but I need the adapter for the "block" basically and the oil return line to the motor. I dont know what size it is so I dont know what to buy.

 

So basically, you need the little fitting that goes from the block on the front iron to the AN fitting on the ss turbo feed line? For the return line, its good to use like -10 ss line.

 

Exactly, Do you know what size that is?

 

hmm.. I want to say M12x1.5. PM El Nene 7. He had the same problem and ended up finding the right size.

 

turbonetics sells the flange you need its 3/8 pipe fitting for use of AN lines

 

Also ATP turbo:

http://www.atpturbo.com