i over heated my tII a couple of monthe ago and just got around to taking it apart and there is oil in the inlet to the turbo so any one care to give me the worst possible case scenario any ideas are aprreciated i plan on rebuilding the engine soon and am going to redo allo the coolant seals that are around the rotor housings and am going to port the engine while there do you think that the turbo bearings were posibly bad all of this stuff sat up for months exposed to open air in a junk yard before i used this stuff the engine ran maybe two hours tops and most of that at idle while i was checking things out
any help is appreciated

 

you need to rebiuld or replace your turbo. sorry check the woble it could also be blow by get in through the pcv but not likly

 

a little oil is ok i think, as long as ther is no puddling

 

well it was complelty covered i do not think it wuld quaify as a little oil that sucks any recomendations of a good turbo to get me into the low 12 do not care about lag b/c this is my cruising car but do not want to go to a stand alone computer i no i am going to need a fuel computer and boost computer as well as 1200 cc injectors but i want it done on the stock computer with add ons