2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

oil buzzer

Thread Tools
 
Search this Thread
 
Old Mar 15, 2015 | 06:14 PM
  #1  
rocker1337's Avatar
Thread Starter
Junior Member
 
Joined: Jul 2013
Posts: 49
Likes: 0
From: Chino
oil buzzer

So my oil sensor went bad. It's always buzzing. Bought a new one. Dumb question but where is it located so I can replace it?

S5 rx7
Reply
Old Mar 15, 2015 | 06:23 PM
  #2  
satch's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 11,738
Likes: 16
From: tulsa,ok.
If you are talking about the oil level sensor it is screwed into the side of the oil pan. It has red/Blue wire to it.

Last edited by satch; Mar 15, 2015 at 06:35 PM.
Reply
Old Mar 15, 2015 | 06:26 PM
  #3  
misterstyx69's Avatar
Retired Moderator, RIP
Tenured Member: 20 Years
iTrader: (142)
 
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
I'll bet you that the wire on the top Sensor on the Rad is busted.
(low level coolant sensor).
The oil level sensor and coolant level sensor make the same noise when there is an issue.
Reply
Old Mar 15, 2015 | 06:26 PM
  #4  
barkz's Avatar
Rotary Enthusiast
Tenured Member 05 Years
iTrader: (1)
 
Joined: Sep 2011
Posts: 1,261
Likes: 1
From: New Hampsha
Dumb question, how do you know it's bad if you don't even know where it is?
Reply
Old Mar 15, 2015 | 07:20 PM
  #5  
roTAR needz fundZ
Tenured Member 15 Years
iTrader: (1)
 
Joined: Aug 2002
Posts: 2,614
Likes: 31
From: Freeland, MI
Originally Posted by barkz
Dumb question, how do you know it's bad if you don't even know where it is?
this is what I like to call a "parts changer" just throw parts at it and hope it fixes it instead of actually finding out what is wrong

I agree with styx though, but, granted the buzzer is the same, but the light on the idiot cluster "should" like up being it was either oil or coolant.....that is "should"
Reply
Old Mar 16, 2015 | 10:56 AM
  #6  
rocker1337's Avatar
Thread Starter
Junior Member
 
Joined: Jul 2013
Posts: 49
Likes: 0
From: Chino
yeah i found it, havent quite gotten the time to replace it.

symptoms are:

turn the key to I the oil buzzer sometimes goes off (as well as the oil level light)
turn the key to II oil buzzer goes off indefinitely as well as the oil level light

warm up for 3-5 minutes then the oil buzzer + light goes away and never comes back on.

car has plenty of oil, i went down there and noticed a small cut in the wire, not deep but there is copper exposed. It was probably shorting out or something?



Ill double check the rad sensor as well. going to be replacing the oil level one tomorrow
Reply
Old Mar 17, 2015 | 08:39 AM
  #7  
invinciblejets's Avatar
Grabba Dabba Goo!
 
Joined: May 2013
Posts: 317
Likes: 0
From: murrells inlet sc
I'd check your coolant level also. Maybe bleed it too.
If either switch was bad it most likely would not shut off by its self buzzer would just stay on.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
3rd Generation Specific (1993-2002)
13
Jan 9, 2018 11:19 AM
troym55
3rd Generation Specific (1993-2002)
23
May 25, 2016 12:42 PM
tiger18
3rd Generation Specific (1993-2002)
9
Sep 3, 2015 08:27 PM




All times are GMT -5. The time now is 09:21 PM.