2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

odd idling problem, and cant find any answers yet

Thread Tools
 
Search this Thread
 
Old Jun 5, 2004 | 06:36 PM
  #1  
Kornate1's Avatar
Thread Starter
Junior Member
Tenured Member 10 Years
 
Joined: Jan 2004
Posts: 18
Likes: 0
From: Florida
odd idling problem, and cant find any answers yet

when i crank up my 87 gxl N/A it takes longer than normal to crank, and when it does, runs rough, thru all rpms, also now blows out quite a bit of white smoke, especially when u rev it up. this whole problem happened when i cranked it up one morning, and it cranked up slow, then a moderately loud pop sound happened, and then it cranked over when i tried to crank it right afterwards. also wondering if feeling warm air over the engine is normal, like around the top of it, near the throttle. I hope someone could tell me whats wrong.
Reply
Old Jun 5, 2004 | 11:49 PM
  #2  
kel's Avatar
kel
24 yrs driving 2nd Gen RX
Tenured Member: 20 Years
 
Joined: May 2002
Posts: 528
Likes: 0
From: A Mile Closer to God (Denver)
White smoke most always is caused from antifreeze getting into the combustion chamber.
With the pop sound you described, I don't believe there is any good news.
If the smoke smells like maple syrup, you've likely blown a coolant seal.
Bad News: time for a rebuild.

- k -
Reply
Old Jun 6, 2004 | 05:32 PM
  #3  
Kornate1's Avatar
Thread Starter
Junior Member
Tenured Member 10 Years
 
Joined: Jan 2004
Posts: 18
Likes: 0
From: Florida
well i got it to crank again, the white smoke is gone, so, i'm guessing that was just from it being a bit flooded, the exhaust has no smell to it, at least like a leak, like how it use to. and there isnt a sweet smell to it either. If its needing a rebuild where should i look to get one at?
Reply
Old Jun 6, 2004 | 06:42 PM
  #4  
WAYNE88N/A's Avatar
Lives on the Forum
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 5,721
Likes: 3
From: Coldspring TX
check your radiator for overpressure/ bubbles first, and check your compression, if everything's good, don't worry about a rebuild just yet...(you did say it quit smoking, right?)
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
stickmantijuana
Microtech
30
Apr 23, 2016 06:37 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
Jmolina0163
1st Generation Specific (1979-1985)
10
Oct 3, 2015 10:04 AM
rotor_veux
2nd Generation Specific (1986-1992)
10
Aug 23, 2015 09:06 PM




All times are GMT -5. The time now is 09:24 PM.