OBD Tool ?
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
No.
The 2nd gen has only the most rudimentary diagnostic functions and can only be accessed using a Mazda tool (or simply jumping the code terminals....check the FAQ for code reading info).
The 2nd gen has only the most rudimentary diagnostic functions and can only be accessed using a Mazda tool (or simply jumping the code terminals....check the FAQ for code reading info).
still love the FC
Joined: May 2002
Posts: 360
Likes: 0
From: Dayton, Ohio
There is no standardized OBD II interface on any US RX-7. The check engine light and flashing ECU codes are it (OBD I style). I guess that is not explicitly covered in the FAQ.
You could get an RTek7 ECU and a PDA or possibly some other aftermarket full or piggyback ECU depending on what information you want.
You could get an RTek7 ECU and a PDA or possibly some other aftermarket full or piggyback ECU depending on what information you want.
still love the FC
Joined: May 2002
Posts: 360
Likes: 0
From: Dayton, Ohio
I was updating my bookmarks today. Here's a link to how to read the codes.
http://fc3spro.com/TECH/HOWTO/ERRORC...KI/kerror.html
http://fc3spro.com/TECH/HOWTO/ERRORC...KI/kerror.html
i'll blow YOUR valve off
Joined: May 2004
Posts: 1,064
Likes: 0
From: KC MF MO
The ONLY way to check rx codes is with a mazda tester or a multimeter/light/etc. They don't use any standard and only have about 15 codes total. When things go wrong, start a thread in this section 
Last edited by Aaron Cake; Aug 16, 2007 at 03:17 PM. Reason: Remove potential rudeness due to complaint
Thread
Thread Starter
Forum
Replies
Last Post