hey all i just successfully installed a new clutch over the past week my series 4 n/a vert has been on jack stands and now fully assembled it wont start? indeed it turns over and even started twice but was very "unorganized: hard running" it shook i gave it the gas till about 3k rpm it also had very white smoke with strong smell but could of been the starting fluid i decided to let it set over night before i decided to mess with it any more (also the - battery cable was disconnected during the install its an optima yet i had to work on it over a long period of time little by little) any suggestions on bleeding the clutch because the clutch doesn't have the usuall pressure...i followed the procedure in the hanes manual (would this be a contributing problem?)