2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Noise driving me crazy

Thread Tools
 
Search this Thread
 
Old Oct 6, 2002 | 09:47 PM
  #1  
RotaryForce13B's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2002
Posts: 203
Likes: 0
From: Baton Rouge, La.
Unhappy Noise driving me crazy

My car has been making a strange noise and I was wandering if any of you have experienced the same problem. The only way I can explain the noise is it sounds like lifters are chattering on a V-8 under acceleration. This noise don’t happen all the time it just does it sometimes but when it does it hesitates a little bit. Has anybody experienced this and if so what’s the remedy

Thanks,
Warren
Reply
Old Oct 6, 2002 | 10:19 PM
  #2  
RotaryForce13B's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2002
Posts: 203
Likes: 0
From: Baton Rouge, La.
I guess nobody wants to touch this one........huh?


Warren
Reply
Old Oct 6, 2002 | 10:24 PM
  #3  
Rs4Racer's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Sep 2002
Posts: 422
Likes: 0
From: Washington
hey i personally dont know but you have to give us more then a half hour to reply.. everyone isnt on 24/7
Reply
Old Oct 6, 2002 | 10:35 PM
  #4  
RotaryForce13B's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2002
Posts: 203
Likes: 0
From: Baton Rouge, La.
Sorry, just a little over excited!
Reply
Old Oct 6, 2002 | 11:01 PM
  #5  
Rotorific's Avatar
I dont know a damn thing
Tenured Member 10 Years
iTrader: (1)
 
Joined: May 2001
Posts: 1,703
Likes: 1
From: Evans, Ga
explain more it may be coming from your tranny
Reply
Old Oct 6, 2002 | 11:21 PM
  #6  
RotaryForce13B's Avatar
Thread Starter
Full Member
Tenured Member 10 Years
 
Joined: Aug 2002
Posts: 203
Likes: 0
From: Baton Rouge, La.
its hard to explain it seems to do it most in 1st, 2nd & 3rd gear. Its not like a clutch chatter. it kind of sounds like a bad rod bearing or something (if it was a V-8).

it wouldnt have anything to do with the end play?
I had to remove the front cover (about 2 months ago) to replace the gasket (it was leaking oil badly where the cover meets the block) and someone (not on this club) told me if i wasnt careful i could screw up the end play. Is that so?

Thanks,
Warren
Reply
Old Oct 7, 2002 | 02:26 AM
  #7  
hypntyz7's Avatar
Banned. I got OWNED!!!
Tenured Member 10 Years
 
Joined: Jul 2001
Posts: 3,052
Likes: 1
From: usa
car, year, model mods? turbo nonturbo?

sounds like maybe pinging/detonation a little form your description. Be careful, *if* this is the cause, it can kill your rotary in a matter of a few runs.

Culprits could be bad gas, high intake temps, dirty plugs, too much boost, too little fuel, etc.
Reply
Old Oct 7, 2002 | 10:49 AM
  #8  
Junior Member
Tenured Member 10 Years
 
Joined: Aug 2002
Posts: 36
Likes: 0
From: Singapore
Hi Pal,
I experience this before, and make like a idiot asking around. The solution for the illness;

1. Change both U-joint that is located on the tip of the propeller shaft "Long shaft" that link from the tranny to the rear diff.

2. After this is done, make sure the propeller shaft is well balanced.

3. Change away the gear lever bushing "the 1 sitting at the tip of the gear lever stick" which is white if it worn out.

Tips for temporary remedy;
Open up your gear lever stick, stuff some heat resistant filter, like those filter use for fish tank "Black" in colour into the square box, dun stuff too much! remenber to add in lithium grease. this will help to take away the sound, but it will be abit stiff to engage your gear...

Cherze.....

Winson Ang
Singapore 13B Fc3-s
Reply
Old Oct 7, 2002 | 12:35 PM
  #9  
sirkus's Avatar
Full Member
Tenured Member 05 Years
 
Joined: May 2002
Posts: 97
Likes: 0
From: Cartersville, Ga
I have a strange sound too, I just got me something called Bass and covered that up , I think it just may be the tranny, I put a new shift boot on and it got more quiet.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Th0m4s
Build Threads
25
Feb 26, 2019 02:04 AM
ncds_fc
2nd Generation Specific (1986-1992)
17
Sep 10, 2015 03:52 AM
fastsaab
New Member RX-7 Technical
5
Aug 19, 2015 11:42 AM
andyvideopro
General Rotary Tech Support
2
Aug 11, 2015 09:16 PM




All times are GMT -5. The time now is 07:47 PM.