2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

No Start....BUT I THINK I HAVE IT!!!

Thread Tools
 
Search this Thread
 
Old Jun 24, 2005 | 01:15 AM
  #1  
RRTEC's Avatar
Thread Starter
Rotartist
Tenured Member 10 Years
iTrader: (13)
 
Joined: Sep 2003
Posts: 7,252
Likes: 2
From: Spring Hill TN 37174
No Start....BUT I THINK I HAVE IT!!!

My brother-in-law is fixing up a nice 87 Sport model... It will NOT start on it's own power. Cranks slowly and just floods out.... He just replaced all the intake side gaskets and the thing still wouldn't start, so we mmo'd it....

Well No luck.. So I said F-it.... And chained it to my blazer and pulled it to the end of the driveway, gave it a little push and the thing fired right up and idled ( a little high mind you 1500 rpms) I drove it around for about 10-20 minutes then parked it...

Battery reads good even with a jump still no start on it's own.. Push it a foot and pop it it fires right up.

I think the starter must be weak... Because the motor barely turns under its own power, it sounds like this....RR_______RRR_____RRR

But the car has pleanty of power while driving so compression isn't a real issue...

I guess starter, what do you think?
Reply
Old Jun 24, 2005 | 01:17 AM
  #2  
88t2romad's Avatar
(_8(|)
Tenured Member 05 Years
 
Joined: Jul 2004
Posts: 2,034
Likes: 0
From: Manhattan, Kansas
make sure the starter ground is hooked up good, i made this mistake when i replaced my clutch a while ago.....

Last edited by 88t2romad; Jun 24, 2005 at 01:18 AM. Reason: type-o
Reply
Old Jun 24, 2005 | 01:20 AM
  #3  
RRTEC's Avatar
Thread Starter
Rotartist
Tenured Member 10 Years
iTrader: (13)
 
Joined: Sep 2003
Posts: 7,252
Likes: 2
From: Spring Hill TN 37174
I will be sure to check that.... I also made sure the belts weren't under too much tension...
Reply
Old Jun 24, 2005 | 03:04 AM
  #4  
RETed's Avatar
Lives on the Forum
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 26,664
Likes: 23
From: n
Check battery termminals.
Bad / corroded battery terminals doesn't allow for full power to get to the starter no matter what you do.



-Ted
Reply
Old Jun 25, 2005 | 10:44 AM
  #5  
RRTEC's Avatar
Thread Starter
Rotartist
Tenured Member 10 Years
iTrader: (13)
 
Joined: Sep 2003
Posts: 7,252
Likes: 2
From: Spring Hill TN 37174
Will do... The battery was relocated to the rear, the terminals appear to be new but I was wondering if maybe the relocation could cause this?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
thunder01
1st Generation Specific (1979-1985)
8
Nov 7, 2006 10:40 PM
Whizbang
2nd Generation Specific (1986-1992)
6
Aug 31, 2005 02:55 PM
wfenris
2nd Generation Specific (1986-1992)
8
Apr 6, 2002 12:33 AM




All times are GMT -5. The time now is 08:04 PM.