No clutch pressure
#1
Junior Member
Thread Starter
Join Date: Oct 2004
Location: SC
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
No clutch pressure
I ran my car for the first time in about six months today and everything worked fine except for the clutch. I never had any problems with the clutch before and the fluid is still where it should be. Any idea whats wrong? I also changed radiators and then new one doesnt have a plug for the sensor, so what do i need to do to get the warning buzzer to turn off?
#2
Full Member
iTrader: (1)
Check the slave cylinder (on the tranny) to see if it is leaking. It is probably okay (since your fluid level has not dropped), the problem is probably the master cylinder.
The best thing to do for the radiator is to weld in a bung and add the water level sensor to the new radiator. If you don't want to do that, grounding the wire that used to go to the sensor will stop the buzzer, but you lose the low coolant indicator. Make sure to keep an eye on the coolant level and the temp gauge!
The best thing to do for the radiator is to weld in a bung and add the water level sensor to the new radiator. If you don't want to do that, grounding the wire that used to go to the sensor will stop the buzzer, but you lose the low coolant indicator. Make sure to keep an eye on the coolant level and the temp gauge!
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM