new rad help *pics*
Thread Starter
Full Member
Joined: Feb 2004
Posts: 136
Likes: 0
From: pinellas park, florida
new rad help *pics*
OK, I got this radiator.. and its for my year but it dosnt seem to match up. If you look at the first pic the radiator shows mounting holes on the side of the rad. and the second pic in my car, bolts go in straight threw, not sideways. Is there some sort of mounting brackets I need or somthing for this? Because I just dont understand it. oh and the third pic is my old leaky rad, that looks way diffrent.. but yet fits..?




I used a high-strength 2-stage Epoxy last time I did that, worked well. I suppose JB weld or something similar may work also, just make sure the 2 surfaces are very clean, sand them off to bare metal,no dirt, etc..
Trending Topics
That rad you pulled out is for a 86-88 and it is not a stock one. it has been replaced before....
the stock ones have bolt on brackets. and the 89-91 ones have bolt on filler necks.
you need both of these to put your new rad in. and you don't have either... you are pretty screwed. you will have to try to find a cheap or free stock damaged rad to take the brackets and filler neck off of.
the stock ones have bolt on brackets. and the 89-91 ones have bolt on filler necks.
you need both of these to put your new rad in. and you don't have either... you are pretty screwed. you will have to try to find a cheap or free stock damaged rad to take the brackets and filler neck off of.
Last edited by Scott 89t2; May 16, 2004 at 09:22 PM.
Thread Starter
Full Member
Joined: Feb 2004
Posts: 136
Likes: 0
From: pinellas park, florida
well.. I'm going to go to the local shop that specializes in mazda's and rotary, especially rx7's callled mazsport. They will probably have an old one layin around i can get the both off of. If not, someone on this forum is ganna hook me up, RIGHT!??? =]


