The kit that has the additional injectors in the crossover pipe ?

Anyone ? I dont want to just connect pipes and see what fits. Just want to do it right.

 

Anyone have a pic?

 

http://www.cochran-racing.com/interc...tercooler.html

I had the HKS piping kit with the extra injectors. It was missing a peice so i just had the peice made... I'm sure this is pretty close to the way it should be but I had to customize a little bit because of my "custom brackets"

 

interesting thanks man =D

how do you keep the hood closed?

 

isnt that center reinforcement "bar" needed??? how does cutting it affect your strength??
thanks

 

looks like it's intalled wrong.

 

this picture is better

 

I have the old greddy's one , actually this kit is for upgrade turbo, I have to custom made a pipe to the intercooler inlet (the silver pipe), the original one is go
underneath the car and go to the intercooler.

 

The HKS piping is not ment to turn the compressor wheel upside down.

My car will have hood pins, I will be welding a new peice of stronger metal just below the intercooler piping. The sheet metal that was there was VERY flimsy, however i'm told it provides a small amount of structural support.

 

It's not installed wrong... It's just installed "different"

 

Where does the U shape piping go?

 

u

 

looks great thanks guys i got some random pipes looked very scary =D

 

What about the U shaped pipe

 

I'll try to get a picture of it next time i'm out but it goes from the turbo then ducts down through a hole i cut in the side of the rad support.

 

i got it kinda hooked up looks very getto fabolous lol how do you get from the turbo to the IC? cut a hole by the light or just go under the top piping?